Lower Water Pressure in Highland, CA

Lower Water Pressure in Highland, CA

If you ever begin to experience a reduction in water pressure, the difficulty are often times within your plumbing system. The following are examples of the common factors to consider when troubleshooting a low pressure situation.

Obstructed Aerators

If the decreased water pressure is coming from a certain faucet, this challenge might be a clogged or impeded aerator. Unscrew the end of the faucet, and examine the aerator screen for decay, waste, rust and other blockages that will be limiting flow. In some respect it can be best to just clean or upgrade the sink aerator altogether.

No Pressure in Hot Water

If your decrease in water pressure may seem to merely be having an effect on the hot water, there might be an issue with your hot water heater. Check the shutoff valve near the hot water heater, ensuring that it is totally opened up. You might have to consult with an accredited plumber to confirm the healthiness of your water heater and find out if this is the source of problems of low water pressure.

Pressure Reducing Valves

If ever the low water pressure condition is present throughout the home, you should check your PRV. This is usually a bell-shaped instrument, and it is generally seen where the main line enters the building. If your PRV valve was improperly fine-tuned or fails, it can cause a pressure loss, as well as no water flow to your property.

Shutoff Valves

Most households and organizations have a main shut off valve. The position can vary, but most of the time it’s going to be discovered in a different box behind the water meter or next to the pressure reduction valve. This kind of valve, which lets you shut off the water flow to the house, can reduce the flow if it isn’t wide open. Even though a little closed, this shut-off valve can confine flows and reduce water pressure.

Mineral Deposit Buildup

In older more mature family homes, plumbing including galvanized pipes can often be uncovered. As time goes on, minerals can take shape on the inside of the pipes and consequently limit the interior size of the pipe, combined with the making of the interior components of the pipe to be rough. Though this deterioration does not produce a health risk, this will minimize your water flow and water pressure. If you ever find this as the source of your problem, your only option would be to replace the plumbing in your house utilizing PEX or copper repipe.

Demands on Your Water System

In case the pressure appears just a bit lower at certain times throughout the day, you’re likely to be observing the effect of a peaking demand on the water system. There are usually two peak time periods through the day. The initial one is very early in the morning when most people are getting ready to go to work or school. And the other is the evening hours when people are arriving back home from work. During that time they are quite often doing laundry, bathing, or watering their lawns. Of these times, you might notice a decrease in pressure, however you should still have acceptable water providing you do not also have one of many issues described in one of the other problem solving procedures.