Trouble shooting Reduced Water Pressure

When you begin to experience a reducing of water pressure, the difficulty are often times inside of your plumbing system. Listed below are a number of the common factors to consider when troubleshooting a low pressure situation.

Malfunctioning Aerators
If ever the decreased water pressure is coming from the faucet, the specific situation might be a clogged or obstructed aerator. Remove the faucet, and check the aerator screen for rust, particles, lime buildup and other debris that will be constraining flow. In some cases it might be much easier to simply just completely clean or change out the sink aerator entirely.

No Pressure in Hot Water
If the low water pressure seems to merely be affecting hot water, there may be an issue with ones hot water heater. Check out the shut off valve close to the water heater, making sure that it is totally opened up. You might need to consult with an accredited plumbing technician to be sure of the health of your water heater and determine if this is the source of problems of low hot water pressure.

PRV (Pressure Reduction Valve)
If the low water pressure condition occurs throughout the home, you should check your valve. This is usually a bell shaped device, and is most regularly seen close to where the main line comes into the home. If your PRV valve was improperly fine-tuned or fails, it can cause a pressure loss, or possibly no water supply to the house.

Shut off Valve
Lots of houses and companies have a master shut-off valve. The location can differ, but most of the time it’s going to be located within a different box behind the water meter or next to the pressure reducing valve. This valve, which allows you to turn off the water flow to the house, can constrain the water flow if it isn’t totally open. Even though just a bit closed, this valve can constrain flows and decrease the water pressure.

Mineral Deposit Buildup
Found in a little older homes, water pipes that include galvanized piping are frequently observed. Over the years, minerals can build inside the water line and thus decrease the inside size within the water line, together with causing the interior components of the pipe to be rough. Even if this wear away may not cause a health risk, this will constrain your circulation and pressure. For those who find this as the source of your trouble, your only solution is to upgrade the plumbing in the home utilizing PEX or copper repiping.

Water System Distribution
When the pressure feels just a little lower at peak times during the day, you could be discovering the consequence of demand peak on the water system. There’s most often a couple of peak time periods through the day. The first is first thing upon waking when other people are getting prepared for work or school. One other is the evening when you are coming back at home from work. During that time they are usually doing laundry, bathing, or watering their lawn. Throughout these times, you may notice decrease in pressure, however you should still have sufficient water providing you do not also have just one of the challenges described within the other trouble shooting tips.